Warning: include(/home/jasonreese/bigbirdplumbing.com/wp-content/themes/genesis/functions.php): failed to open stream: Permission denied in /home/jasonreese/bigbirdplumbing.com/wp-settings.php on line 323

Warning: include(): Failed opening '/home/jasonreese/bigbirdplumbing.com/wp-content/themes/genesis/functions.php' for inclusion (include_path='.:/usr/local/lib/php:/usr/local/php5/lib/pear') in /home/jasonreese/bigbirdplumbing.com/wp-settings.php on line 323
Water Usage - Gig Harbor Plumber | Plumbing

Water Usage

If your water usage is high and you’re maybe being charged an amount that does’t seem reasonable, these are some potential tests you can do to identify any problems.

  1. Listen for dripping sounds. As simple as this step may seem, it may be overlooked in a busy, noisy home. Even though a dripping faucet may not seem to waste significant amounts of water, over the course of day, each individual drop adds up to thousands and thousands of drops, or gallons and gallons of water. Choose a time when there is little or no activity, such as early in the morning, or late at night, when the house is very quiet.
  2. Look for evidence of a leak along the base board of walls near the location of your plumbing fixtures. Pipes that contain water under pressure can become corroded, develop loose fittings, or crack because of freezing, allowing a continuous loss of water until repaired. Mildew or mold, darkened surfaces, or even puddles of water may occur below leaks. If the problem is inside the wall cavity, it may be necessary to remove the paneling, plaster, or wallboard to correct it.
    • Pipes also may sweat when cold water passes through them in warmer interior airspaces in the home, and this water condensing on the surface of pipes may drip, causing moisture problems to appear where no leak exists. However, consistently sweaty pipes could be a sign a leaky toilet or other fixture.
  3. Look under vanities and sinks for drips or similar evidence noted in the previous step. Use a flashlight to follow the path of exposed pipes, looking for droplets of water that will accumulate at the lower section before dropping off, and run your fingertips along these pipes to feel for wetness.
  4. Listen for noises from your commodes/bathrooms, to determine if they are running at unusual intervals, when no one has recently flushed them. When there is a seal leak in the water closet (toilet), the tank will drain slowly over a period of time, until the water level drops sufficiently for the float valve to open and replenish it. Sticking flush valves and leaking seals in toilets can waste a lot of water, since, like dripping faucets, the flow, although perhaps very small, is continuous.
    • Check the supply valves on lavatories and commodes if they are leaking. The packing, which seals the valve stem of a typical stop (water valve) seals when compressed just enough to “pack off” leak paths, but not so tightly that turning the handle is difficult. Turn the packing nut (top nut surrounding the stem) slightly clockwise (shouldn’t require more than 1/8 turn or so) and see if this stops the leak around the stem. Supply valves are meant to be fully opened or completely closed. Turn the valve off by turning the handle clockwise until it stops; Open the valve by turning the handle counter-clockwise (anti-clockwise) until it stops. Occasionally, a very slight leak of a stem will stop if the valve was partly opened and is either fully closed or opened fully.
  5. Check your water meter. Municipal water systems use a meter to measure the amount of water used, and by turning off all faucets and appliances that consume water, the flow to your home will cease. Locate your water meter, read the amount displayed, note it, then wait an hour or two, and reread it to see if water has gone through it when none was being used in your home. Very small leaks will not appear to move the meter over a short period of time, so these will be harder to detect using this method.
Google+

FREE Consultation!

We are here to provide you with a FREE consultation and estimate regarding the repair, replacement or installation of a variety of plumbing needs.

Contact us at 253.549.5667 today!